Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 58)

Programming Manual

4.7.7 Source - Pulse subsystem

[:SOURce]

:PULSE

:COUNt 1 to 2e8

:DCYCle 0 to 100% pulse width must be >= 0.001

:HOLD WIDTh | DCYCle

:PERiod 0.002 to 90,000

:WIDth 0.001 to < 90,000

The source pulse sub-system is used to program the pulsed output mode of operation of the DC

Supply.

PULSe:COUNt

This command sets the number of pulses that are output when a triggered output transient

occurs. The command accepts parameters in the range 1 through 2E8. If MAXimum is sent, the

output pulse repeats indefinitely.

Command Syntax [SOURce:]PULSe:COUNt<NRf+>

Parameters 1 to 2E8 | MINimum | MAXimum

*RST Value 1

Examples PULS:COUN 3

PULS:COUN MIN PULS:COUN MAX

Query Syntax [SOURce:]PULS:COUNt?

Returned Parameters <NR2>

Related Commands PULS:DCYC PULS:PER PULS:WIDT

PULSe:DCYCle

This command sets the duty cycle of the triggered output pulse. The duty cycle units are

specified in percent.

Command Syntax [SOURce:]PULSe:DCYCle<NRf+>

Parameters 0 to 100%|MINimum|MAXimum

*RST Value 50%

Examples PULS:DCYC 75

PULS:DCYC MAX

Query Syntax [SOURce:]PULSe:DCYCle?

Returned Parameters <NR2>

Related Commands PULS:COUN PULS:PER PULS:WIDT

PULSe:HOLD

This command specifies whether the pulse width or the duty cycle is to be held constant when

the pulse period changes. The following tables describe how the duty cycle, period, and width

are affected when one parameter is set in a single program message. if two or three parameters

are set in a single message, there sequence will define how they will be affected.

KDC Series DC Power Supplies 57

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 58