Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 57)

Programming Manual

4.7.5 Source – Mode subsystem

[:SOURce]

:MODE CVOLtage | CCURrent | CPOWer

[SOURce:]MODE

This command is used to set or query the power supply's operating mode. The power supply

can operate in either Constant Voltage or Constant Current mode. A <CRD> string is returned

for a MODE? Query as shown in the table below:

<CRD> Mode

CVOL Constant Voltage (CV)

CCUR Constant Current (CC)

CPOW Constant Power (CP)

Table 4-1: Mode query results

Command Syntax [SOURce:]MODE <CRD>

Parameters CVOLtage | CCURrent | CPOWer

Example: MODE CVOL

Query Syntax MODE?

Returned Parameters <CRD>

Related Commands VOLT:PROT:DEL

4.7.6 Source – Power subsystem

[:SOURce]

:POWer

[SOURce:]POWer

This command is used to set or query the constant power mode level. This command is only

relevant if the MODE is set to constant power mode. In the CC or CV modes, this setting has no

effect. The power level set cannot exceed the power level of a single KDC unit, either 5000,

10000 or 15000 depending on model configuration. Also make sure the voltage and current

settings are consistent with the desired power level in CP mode.

Command Syntax [SOURce:]POWer <NRf>

Parameters <NRf>

Example: POW 3400

Query Syntax POW?

Returned Parameters <NR2>

Related Commands VOLT:MODE

56 KDC Series DC Power Supplies

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 57