Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 55)

Programming Manual

Command Syntax [SOURce:]LIST:STEP<step>

Parameters ONCE | AUTO

*RST Value AUTO

Examples LIST:STEP ONCE

Query Syntax [SOURce:]LIST:STEP?

Returned Parameters <CRD>

Related Commands LIST:COUN LIST:DWEL

LIST:TTLTrg[:SWITch]

This command sets the sequence of Trigger Out list points. Each point set to “1” will cause a

pulse to be output at Trigger Out (Function strobe) output when that list step is reached. Those

entries which are set “0” will not generate Trigger Out pulses. The order in which the list points

are given determines the sequence in which Trigger Out pulses will be output when a list

transient is triggered.

Command Syntax [SOURce:]LIST:TTLTrg[:SWITch] <bool> ,<bool>

Parameters 0 | 1 | OFF | ON

Examples LIST:TTLT 1,0,1 LIST:TTLT ON,OFF,ON

Query Syntax LIST:TTLT?

Returned Parameters 0 | 1

Related Commands LIST:TTLT:POIN? LIST:COUN LIST:DWEL

LIST:STEP OUTP:TTLT:STAT OUTP:TTLT:SOUR

LIST:TTLTrg:POINts?

This query returns the number of points specified in LIST:TTLT. Note that it returns only the total

number of points, not the point values.

Query Syntax [SOURce:]LIST:TTLTrg:POINts?

Returned Parameters <NR1>

Example LIST:TTLT:POIN?

Related Commands LIST:TTLT

LIST:VOLTage[:LEVel][:AMPLitude]

This command specifies the output voltage points in a list. The voltage points are given in the

command parameters, which are separated by commas. The order in which the points are

entered determines the sequence in which the list will be output when a list transient is

triggered.

Command Syntax [SOURce:]LIST:VOLTage[:LEVel][:AMPLitude] <NRf+>,<NRf+>

Parameters 0 to MAX

Unit Volt

Examples LIST:VOLT 2.0,2.5,3.0

Query Syntax [SOURce:]LIST:VOLTage[:LEVel]?

Returned Parameters <NR2>

Related Commands LIST:VOLT:POIN? LIST:COUN LIST:DWELLIST:STEP

LIST:VOLTage[:LEVel]:POINts?

This query returns the number of points specified in LIST:VOLT. Note that it returns only the

total number of points, not the point values.

54 KDC Series DC Power Supplies

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 55

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Argantix KDC 80-62