Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 72)

Programming Manual

Command Syntax SYSTem:COMMunicate:SERial:BITS <NRF>

Parameters 7|8

Example SYST:COMM:SER:BITS 8

Returned Parameters <NR1>

SYSTem:COMMunicate:SERial:SBITs

This command will set the SERial communication number of stop bits.

Command Syntax SYSTem:COMMunicate:SERial:SBITs <NRF>

Parameters 1|2

Example SYST:COMM:SER:SBITs 1

Returned Parameters <NR1>

SYSTem:CONFigure[:BYTE]

This command will set the system configuration. This is a protected command and requires a

password. The query format is available however. Refer to the *OPT? Command for system

options.

Command Syntax SYSTem:CONFigure[:BYTE]

Parameters SCPI, DO160,MIL704, FT

Example SYST:CONF SCPI SYST:CONF?

Returned Parameters <CRD>

Related Commands *OPT?

SYSTem:ERRor?

This query returns the next error number followed by its corresponding error message string

from the remote programming error queue. The queue is a FIFO (first-in, first-out) buffer that

stores errors as they occur. As it is read, each error is removed from the queue. When all errors

have been read, the query returns 0,”No Error”. If more errors are accumulated than the queue

can hold, the last error in the queue is -350,”Queue overflow”.

Query Syntax SYSTem:ERRor?

Parameters None

Returned Parameters <NR1>,<SRD>

Example SYST:ERR?

SYSTem:ETIMe?

This command will return the total number of accumulated hours, minutes and seconds.

Command Syntax SYSTem:ETIMe?

Parameters none

Example SYST:ETIM?

Returned Parameters <NR1>,<NR1>,<NR1>

SYSTem:LOCal

This command sets the interface in Local state, which enables the front panel controls. This

command only applies to the RS232C interface. If IEEE 488 is used, the remote/local state is

determined by the REN line on the IEEE 488 interface. In GPIB model, the SYST:LOC and

SYST:REM commands will not be accepted and will generate an error message.

KDC Series DC Power Supplies 71

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 72