Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 111)

Programming Manual

Appendix C: Error Messages

Any errors that occur during operation from either the front panel or the remote control interface

will result in error messages. Error messages are displayed on the LCD display. They are also

stored in the error message queue from which they can be queried using the SYST:ERR?

Query. The error queue has a finite depth. If more error messages are generated than can be

held in the queue, a queue overflow message will be put in the last queue location. To empty the

queue, use the error query until the No Error result is received.

Errors appearing on the LCD will generally remain visible until the user moves to another

screen. If multiple error messages are generated in succession, only the last message will be

visible as there is only space for one error message on the LCD display.

The same area of the display is also used to display status messages. While error messages

always have a negative error number, status messages have a positive number.

The table below displays a list of possible error and status messages along with their possible

cause and remedy.

Number Message String Cause Remedy

0 "No error" No errors in queue

-100 "Command error" Unable to complete

requested operation

Unit may be in a mode inconsistent

with request.

-102 "Syntax error" Command syntax

incorrect.

Misspelled or unsupported command

-103 "Invalid separator" SCPI separator not

recognized

See SCPI section of programming

manual.

-104 "Data type error" Data type invaled. Check command for supported data

types

-108 "Parameter not

allowed"

One or more

additional parameters

were received.

Check programming manual for

correct number of parameters

-109 "Missing parameter" Too few parameters

received for

requested operation

Check programming manual for

correct number of parameters

-110 "Command header

error"

Command header

incorrect

Check syntax of command.

-111 "header separator

error"

Invalid command

separator used.

Use semi-colon to separate command

headers

-112 "Program mnemonic

too long"

Syntax error Check programming manual for

correct command syntax

-113 "Undefined header" Command not

recognized error

Check programming manual for

correct command syntax

-120 "Numeric data error" Data received is not a

number

Check programming manual for

correct command syntax

-121 "Invalid character in

number"

Number received

contains non-numeric

character(s)

Check programming manual for

correct command syntax

-123 "Exponent too large" Exponent in number

exceeds limits

Check programming manual for

correct parameter range

-128 "Numeric data not

allowed"

Number received

when number is not

allowed.

Check programming manual for

correct command syntax

-168 "Block data not Block data was sent. Check programming manual for

110 KDC Series DC Power Supplies

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 111

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Argantix KDC 80-62