Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 10)

Programming Manual

2 Remote Control

2.1 Introduction

The KDC Series comes standard with an RS232C serial interface on the rear panel. It can

optionally be furnished with a combination IEEE-488 and analog control interface at the time of

purchase. The GPIB interface is part of the -IF option package.

Units are shipped with the Argantix KDC Graphical User Interface program - KDCGUI. This

Windows™ program provides a soft front panel to the instrument when connected to a PC

through the RS232C or IEEE-488 interface. Additional benefits are obtained from using the PC

as a control interface. Some of these benefits include the ability to store measurement data to

disk and produce output transients to simulate various DC supply conditions.

The KDCGUI is a Windows™ program and as such requires a PC capable of running Windows

98™, or Windows NT /2000/XP. For best performance, a Pentium based PC is recommended.

Note: The KDCGui was developed to work with the National Instruments Gpib-32.dll only. For

use over the GPIB bus, a National Instruments brand GPIB controller is required in the PC.

Complete information on how to use the KDCGUI can be found in the on-line help supplied with

the program. Use the Help menu or press on any of the many Help keys located in all program

windows for an explanation of the relevant screen or function.

Figure 2-1: KDCGUI Main screen

KDC Series DC Power Supplies 9

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 10