Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 17)

Programming Manual

Procedure

1. Make sure the KDCGUI program is closed and no device

is using the com port in use.

2. From the Windows desktop, right click on the “My

Computer” icon which is located in the top left corner of

the screen.

3. From the popup menu, select the “Properties” entry.

4. This brings up the System Properties dialog box

5. From the tabs shown at the top of the dialog box, select

the “Device Manager” tab.

6. The relevant screen is shown in Figure 2-3.

7. Expand the Ports(COM&LPT) tree selection by clicking on

the ‘+’ sign

8. Select the COM port you plan to use to communicate with

the P or KDC Series power supply.

9. With the correct COM port selected, click on the

Properties button at the bottom left of the dialog box.

10. This brings up the settings dialog box for the COM port. In

this example, COM2 is used.

11. From the tabs at the top of the dialog box, select the “Port Settings”

tab.

Figure 2-3: System Properties Dialog Box

12. This should bring up the dialog shown in Figure 2-5.

13. Next, select the Advanced button to bring up the advanced port settings dialog box shown in Figure

2-4.

16 KDC Series DC Power Supplies

14. At the top of the dialog box, disable the “Use FIFO buffers

(requires 16550 compatible UART)” checkbox. This will

bypass the UART FIFO’s and enable the hardware

handshake to work correctly.

15. Click on the all OK buttons to close all dialog boxes that

remain open.

16. This should enable the KDCGUI to work correctly.

Figure 2-4: Advanced Port Settings Dialog Box

Figure 2-5: COM Port Properties Dialog Box

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 17