Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 42)

Programming Manual

4.5 Output Subsystem

This subsystem controls the main outputs, the signal outputs and the output impedance of the

DC supply.

Subsystem Syntax

OUTPut

:IMPedance

[:STATe] Enable/disable output impedance program

:REAL Sets resistive part of output impedance

RI[:LEVel] Sets Remote Inhibit input level mode (LOW | HIGH).

[:STATe] Enable/disable output voltage, current, power, etc.

:TTLTrg

[:STATe] Enable/disable trigger out drive

:SOURce Selects a TTLTrg source (BOT|EOT|LIST)

OUTPut:IMPedance[:STATe]

This command enables or disables the supply's output impedance programming. The state of a

disabled output impedance is equivalent to the minimum impedance. The query form returns the

output state.

Command Syntax OUTPut:IMPdance[:STATe]<bool>

Parameters 0 | OFF | 1 | ON

*RST Value OFF

Examples OUTP:IMP 1 OUTP:IMP:STAT ON

Query Syntax OUTPut:IMPdeance[:STATe]?

Returned Parameters 0 | 1

Related Commands OUTPut:IMPedance:REAL

OUTPut:IMPedance:REAL

This command sets the real part of the output impedance of the AC source in mili-ohms.

OUTPut:IMPedance:STATe must be enabled for the programmed impedance to affect the

output. The available range is a function of voltage and current range of the DC supply and can

be queried using the "OUTP:IMP:REAL? MIN" and "OUTP:IMP:REAL? MAX" commands

Command Syntax OUTP:IMPedance:REAL<NRf>

Parameters model specific.

*RST Value min

Examples OUTP:IMP:REAL 20

Query Syntax OUTPut:IMP:REAL?

Returned Parameters <NR2>

Related Commands OUTP:IMP

KDC Series DC Power Supplies 41

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 42