Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 68)

Programming Manual

4.8.2 Status – Questionable Status Group

Subsystem Syntax

STATus

:QUEStionable

:CONDition Returns the value of the condition register

:ENABle <n> Enables specific bits in the Event register

:EVENt Returns the value of the event register

Bit Configuration of Questionable Registers

Bit Position 15 14 13 12 11-10 9 8-5 4 3 2 1 0

Bit Name LOV LUV CV CC n/a RI n/a OT n/a OVP CF VF

Bit Weight 32768 16384 8192 4096 512 16 8 4 2 1

LOV Line input over voltage protection has tripped

LUV Line input under voltage protection has tripped

CV Unit operating in Constant Voltage mode (status bit)

CC Unit operating in Constant Current mode (status bit)

RI remote inhibit is active

OT over-temperature protection has tripped

OVP Over voltage protection has triggered

CF Over current protection has tripped

VF Output under voltage (UV) or over voltage (OV) has occurred

STATus:QUEStionable:CONDition?

This query returns the value of the Questionable Condition register. This is a read-only register

which holds the real-time (unlatched) questionable status of the AC/DC power source.

Query Syntax STATus:QUEStionable:CONDition?

Example STAT:QUES:COND?

Returned Parameters <NR1>(Register value)

STATus:QUEStionable:ENABle

This command sets or reads the value of the Questionable Enable register. This register is a

mask for enabling specific bits from the Questionable Event register to set the questionable

summary (QUES) bit of the Status Byte register. This bit (bit 3) is the logical OR of all the

Questionable Event register bits that are enabled by the Questionable Status Enable register.

Command Syntax STATus:QUESionable:ENABle <NRf+>

Parameters 0 to 65535

*RST Value 0

Examples STAT:QUES:ENAB 18

Query Syntax STATus:QUEStionable:ENABle?

Returned Parameters <NR1>(Register value)

Related Commands STAT:QUES:EVEN?

KDC Series DC Power Supplies 67

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 68