Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 34)

Programming Manual

4.3 Initiate Subsystem

This subsystem controls the triggering of the DC power supply. See section 5.6 under

"Triggering Output Changes" for an explanation of the Trigger Subsystem. The INITiate

commands control the initialization of the transient system. The trigger subsystem must first be

enabled using the INITiate commands or no triggering action will occur. Refer to Figure 5-1 for a

block diagram of the trigger system.

Subsystem Syntax

INITiate

[:IMMediate] Initiates the system for one trigger

[:TRANsient]

:ACQuire

:CONTinuous sets if the initate continuous to (ON|OFF)

INITiate[:IMMediate][:TRANsient]

The INITiate command controls the initiation of the transient generation or measurement

acquisition trigger system. They cause the trigger system to make a transition from the Idle state

to the Waiting-for-Trigger state. If the trigger system is not in the Idle state, the initiate

commands are ignored.

If both the transient generation and the measurement acquisition trigger systems are initiated at

the same time, the first trigger event that occurs will trigger the measurement system. The

transient system will trigger on the next trigger event. Thus, the measurement system has a

higher trigger priority than the the transient system. If the measurement trigger is generated by a

transient event, the acquisition system should be initiated first so it is waiting for the trigger

caused by the transient system.

Command Syntax INITiate[:IMMediate][:TRANsient

Parameters None

Examples INIT

Related Commands ABOR INIT:CONT *TRIG

INITiate:ACQuire

The INITiate:ACQuire command controls the initiation of the measurements trigger system. They

cause the trigger system to make a measurement from the Idle state to the Waiting-for-Trigger

state. If the trigger system is not in the Idle state, the initiate commands are ignored.

Command Syntax INITiate:ACQuire

Parameters None

Examples INIT:ACQ

Related Commands ABOR INIT:CONT *TRIG

INITiate:CONTinuous

These commands control the transient generator trigger system.

 1 or ON continuously initiates the transient trigger system.

 0 or OFF turns off continuous triggering. In this state, the trigger system must be initiated for

each triggered event using INITiate:TRANsient.

KDC Series DC Power Supplies 33

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 119 120

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 34