Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 103)

Programming Manual

7.2 Mil-Std 704 Option -704

MIL704 tests can be executed remotely from the GPIB or RS232 using the following command

tree. See the KDC Series User Manual (P/N 5005-960) for more details about each 704 test

step.

7.2.1 DC System

:MIL704

:VERSion D|E

:SSTate

:VOLT

[:LEVel]

:RIPPle

:TRANsient

:VOLTage

[:LOW]

:HIGH

:ABNormal

:VOLTage

[:UNDer]

:OVER

:EMERgency

:VOLTage

Note that none of these commands accept parameters nor have a query format except for the

MIL704:VERSion command, which accepts a letter D or E as a parameter. Its query format

response will return the letter D or E based on the revision selected.

:MIL704:VERSion

This command sets the Mil Std 704 standard revision to be used. Available versions are D and

E. Older and or newer versions may be added through firmware updates. Note that this is the

only MIL704 command that has a parameter and supports the query format.

Command Syntax :MIL704:VERSion

Parameters D | E

*RST Value E

Examples :MIL704:VERS D

Query Syntax :MIL704:VERSion?

Returned Parameters <CRD>

Related Commands none

:MIL704:SSTate:VOLTage[:LEVel]

This command initiates the Steady state voltage level test step.

Command Syntax :MIL704:SSTate:VOLTage[:LEVel]

Parameters none

Examples :MIL704:SST:VOLT

Query Syntax n/a

Returned Parameters n/a

Related Commands :MIL704:SSTate:VOLTage:RIPPle

102 KDC Series DC Power Supplies

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 103

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Argantix KDC 80-62