Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 63)

Programming Manual

Command Syntax [SOURce:]VOLTage:REFerence <param>

Parameters INTernal | EXT5V | EXT10V | EXTRES

*RST Value INTernal

Examples VOLT:REF INT VOLT:REF EXT10V

Query Syntax [SOURce:]VOLTage:REF?

Returned Parameters <CRD>

Related Commands CURR:REF VOLT

[SOURce:]VOLTage:SLEW[:IMMediate]

This command sets the voltage slew rate. The voltage slew rate determines the rate of change

when a new voltage level is programmed. The maximum slew rate that can be programmed is a

function of the available voltage range and will differ from model to model. The MAX parameter

may be used to set or query the maximum slew rate.

Command Syntax [SOURce:]VOLTage:SLEW[:IMMediate] <NRf>

Parameters 0 to MAX

*RST Value MAX

Examples VOLT:SLEW 100 VOLT:SLEW MAX

Query Syntax [SOURce:]VOLTage:SLEW? MAX VOLT:SLEW?

Returned Parameters <NR2>

Related Commands VOLT:TRIG VOLT

[SOURce:]VOLTage:SLEW:MODE

This command sets the voltage slew rate programming mode. Available modes are:

FIXed The voltage slew level set is unaffected by a triggered output transient.

STEP The voltage slew level set is programmed to the value set by

VOLTage:SLEW:TRIGgered when a triggered transient occurs.

PULSe The voltage slew level set is changed to the value set by

VOLTage:SLEW:TRIGgered for a duration determined by the pulse commands.

LIST The voltage slew level set is controlled by the voltage slew list when a triggered

transient occurs.

The voltage slew may be set between zero and the model's maximum voltage slew capability

(determined by model) which can be queried with the VOLT:SLEW? MAX command.

Command Syntax [SOURce:]VOLTage:SLEW:MODE <mode>

Parameters FIXed | STEP | PULSe | LIST

*RST Value FIX

Examples VOLT:SLEW:MODE LIST VOLT:MODE FIX

Query Syntax [SOURce:]VOLTage:SLEW:MODE?

Returned Parameters <CRD>

Related Commands VOLT:TRIG VOLT

[SOURce:]VOLTage:SLEW:TRIGgered

This command sets the voltage slew rate trigger level. When triggered by a step or pulse

transient, the voltage slew rate will be set to the programmed level. Note that the new slew rate

does not take effect until the unit is armed and a trigger event occurs. A parameter of MAXimum

will set the slew to its maximum possible rate.

The voltage slew may be set between zero and the model's maximum voltage slew capability

(determined by model) which can be queried with the VOLT:SLEW? MAX command.

62 KDC Series DC Power Supplies

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 63

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Argantix KDC 80-62