Argantix KDC 80-62 Manuel d'utilisateur télécharger pdf (Page 50)

Programming Manual

FIXed The current slew level set is unaffected by a triggered output transient.

STEP The current slew level set is programmed to the value set by

CURRent:SLEW:TRIGgered when a triggered transient occurs.

PULSe The current slew level set is changed to the value set by

CURRent:SLEW:TRIGgered for a duration determined by the pulse commands.

LIST The current slew level set is controlled by the current slew list when a triggered

transient occurs.

The current slew may be set between zero and the model's maximum current slew capability

(determined by model) which can be queried with the CURR:SLEW? MAX command.

Command Syntax [SOURce:]CURRent:SLEW:MODE <mode>

Parameters FIXed | STEP | PULSe | LIST

*RST Value FIX

Examples CURR:SLEW:MODE LIST CURR:MODE FIX

Query Syntax [SOURce:]CURRent:SLEW:MODE?

Returned Parameters <CRD>

Related Commands CURR:TRIG CURR

[SOURce:]CURRent:SLEW:TRIGgered

This command sets the current slew rate trigger level. When triggered by a step or pulse

transient, the current slew rate will be set to the programmed level. Note that the new slew rate

does not take effect until the unit is armed and a trigger event occurs. A parameter of MAXimum

will set the slew to its maximum possible rate.

The current slew may be set between zero and the model's maximum current slew capability

(determined by model) which can be queried with the CURR:SLEW? MAX command.

Command Syntax [SOURce:]CURRent:SLEW:TRIGgered <NRf>

Parameters 0 to MAX

*RST Value 0

Examples CURR:SLEW:TRIG

Query Syntax [SOURce:]CURRent:SLEW:TRIG?

Returned Parameters <NR2>

Related Commands CURR:SLEW:MODE CURR:SLEW

[SOURce:]CURRent:TRIGgered[:AMPLitude]

This command sets the current trigger level. When triggered by a step or pulse transient, the

current will be set to the programmed level. Note that the new current setting does not take

effect until the unit is armed and a trigger event occurs. The maximum current that can be

programmed is a function of the model and may be queried using the LIMIT subsystem. It is

also further determined by the user defined CURR:HIGH and CURR:LOW settings.

The current slew may be set between zero and the model's maximum current slew capability

(determined by model) which can be queried with the CURR:SLEW? MAX command.

Command Syntax [SOURce:]CURRent:TRIGgered[:AMPLitude <NRf>

Parameters 0 to MAX

*RST Value 0

Examples CURR:TRIG

Query Syntax [SOURce:]CURRent: TRIG?

Returned Parameters <NR2>

Related Commands CURR:MODE CURR

KDC Series DC Power Supplies 49

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Argantix KDC 80-62 Manuel d'utilisateur Page 50

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Argantix KDC 80-62